Triumph Rocket III Floorboards & Footpegs
!

Billet Passenger Floorboards- Rocket III
!
Larger picture

Superb Billet aluminium passenger floorboards, by Jardine.
Has smooth ball bearing fold up action

Passenger Boards-Triumph Rocket III
!
Larger picture

Increase foot and leg support as well as allowing for a variation in foot

position on long rides. (Shown in pictures with optional Relocation Arm,

sold separately)

Made from billet aluminium and chrome plated finish. The soft, antivibration,

inlaid rubber pads further insure passenger comfort.

They will fold and lock in the up position.

Passenger Board Relocation Arms-Triumph Rocket III
!
Larger picture

When saddlebags are installed on this model there is little or no

room between the passenger peg and the saddlebag for the

passengers heel. By moving the boards forward 4 you will gain

the needed heel room as well as allow the passenger to be in a

more relaxed seating position. The arms have two sets of

alignment holes and can be installed at the original height or 1.5

higher.

Driver Boards-Triumph Rocket III
!
Larger picture
They bolt on in place of the stock driver pegs and measure 5" X 8" which provides full support for your feet as well as room to move around a little on longer rides. Machined from billet aluminum, triple chrome plated with sot anti-vibration Neoprene rubber pads. The boards are hinged on their mounts and will fold up in the event of a tip over. Retains the stock shift and brake pedals while maintaining adequate room above and below.

Brake Pedal Cover-Triumph Rocket III
!
Larger picture
Slips on the existing brake pedal after removing the rubber cover.

Heel/Toe Shifter-Triumph Rocket III
!
Larger picture
Custom designed Heel/Toe Shifter is highly polished and triple-chrome plated. Included are chrome billet shifter Peg Set with rubber inserts.

Kuryakyn Splined Footpeg Adaptors For Triumph
!

Küryakyn Footpegs & Floorboards for peg mounts are a 2-part system for convenience & easy installation. Simply select the floorboards you desire & the appropriate motorcycle specific Splined Adapters for your bike. These Splined Adapters have teeth that match the footpegs or floorboards & allows the angle of the footrest to be set & locked in place.
This convenient 2-part system also allows you to change your footrests without purchasing new splined adapters.
Have a new bike? Simply switch your pegs or floorboards to a new bike by purchasing new Splined Adapters.

Note: Adapters are for stock OEM Peg Mounts.

These Splined adaptors are required for fitting the following products:-
Kuryakyn Flamin' Switchblade Pegs, Liberator Pegs, Liberator Pegs and Stirrups, Swingwing Pegs, Iso-boards Floorboards,  & Constellation floorboards,